CipherLab 1266 Uživatelský manuál stáhnout pdf (Strana 2)

Powering up the CIPHER 1166/1266 Barcode Scanner

When first received the rechargeable lithium ion batteries (two supplied) are stored separately

from the 1166/1266 scanner, 1 of the batteries has to be inserted into the bottom of the scanner’s

handle. It is important to ensure the locking clip on the battery is slid into place to secure the

battery and power on the scanner. If it is planned for the scanner to be not used for a prolonged

period of time it is recommended that the battery is removed and secured separately.

Setup RF Connection (This has initially been done by Dataman)

Upon powering up, the scanner will attempt to establish RF (Radio Frequency) connection with

the base station. At this stage it is necessary to “Pair” the 1166/1266 scanner with the base

station.

First ensure that the base station is connected to the supplied switching adapter and that power is

applied. Next, locate and identify the two labels on the underside of the base station. The first

label has the words “SET CONNECTION” and a barcode, the second label is the serial number.

In order to “Pair” the 1166/1266 scanner with its base, first scan the “SET CONNECTION”

barcode label, the scanner will beep once, following this then scan the serial number barcode.

The scanner will then emit a low and a high beep.

When the 1166/1266 scanner successfully establishes RF connection with the base station the

scanner will emit three short ascending beeps, the “Pairing” is then complete.

Charging the battery

To charge the Scanner’s battery simply place (or park) the scanner’s handle in to the base. The

LED on top of the scanner will flash RED while it charges. When the battery is fully charged

(Approximately 4 hours if the battery was fully discharged) the LED will no longer flash but remain

fixed RED.

Inserting the second spare battery in the front of the base unit will ensure that it is fully charged

and ready for change over while the first battery is being used.

Establishing scanner software setup and configuration

If it is intended for the 1166/1266 Base Station to be connected to the computer using the USB

interface connection it may be necessary to acquire additional cabling accessories and

programmatically reconfigure the scanners internal parameters to the required mode of operation.

(Contact Dataman for additional detail should this ever be required).

Using the supplied Dataman A4 sheet of initializing and setup barcodes titled “Cipher 1166/1266

Wireless Barcode Reader Setup Menu”. Scan each and all of the right hand column of barcodes

from 1 to 11, this will ensure that the 1166/1266 is configured with the best optimum settings for

use in the library and other general purpose applications. This configuration setup should

normally only ever require to be undertaken once.

After scanning the right hand column (and only afterwards) the left hand column of barcodes

provided on the same A4 sheet can also be scanned sequentially from 1 to 6, this will ensure that

the 1166/1266 RF-Shutdown period is turned OFF.

Connecting the Base Station to the Computer

Importantly it is necessary to ensure that the computer is powered down before attempting to

connect the RF Base Station to the computer. Using the supplied Keyboard Wedge “Y” cable

attach the single “D” shaped connector to the matching socket on the base station.

Remove the keyboard plug from its connector at the computer if not already removed.

1 2 3 4 5 6 7 ... 11 12

Komentáře k této Příručce

Žádné komentáře

CipherLab 1266 Uživatelský manuál Strana 2

Komentáře k této Příručce

Související produkty a manuály pro Čtečky čárových kódů CipherLab 1266